Docu ment No. E ZZ024048<1>
Pr epared in October, 2021
9 / 19
8. Push or to select [Trigger Object], then push .
9. Push or to select the trigger target, then push .
Note: If analog trigger is selected for the trigger type, set the trigger target and trigger
level.
10. Push or to select [Trigger Condition], then push .
11. Push or to select the trigger detection conditions, then push .
12. Push or to select [Pre-Trigger Setting], then push .
13. Push or to select the digit, then push or to change the value.
14. When you complete changing the value, push .
The procedure to set the trigger is complete.
To Next Page
Loading...
