YASKAWA GA700 Series - Page 996

Docu ment No. E ZZ024048<1>
Pr epared in October, 2021
12 / 19
No.
( Hex.)
Name
De scription
De fault
( Range)
Re f.
o5-17
( 1E84)
RUN
Analog Trigger
Ob j ect
102
( 0 - 999)
–
Selects the monitor ( Ux-xx ) to set for the analog trigger
target. This parameter is only available when using an
L CD keypad.
o5-18
( 1E85)
RUN
Analog Trigger
L evel
0.0%
( - 999.9% -
+999.9%)
–
Sets the level to compare with the analog trigger target.
Thi s parameter is only available when using an LCD
keypad.
o5-19
( 1E86)
RUN
Trigger Condition
0
( 0 - 1)
–
Selects the condition with which to detect the trigger.
Thi s parameter is only available when using an LCD
keypad.
0: Rising Edge
1: Falling Edge
o5-20
( 1E87)
RUN
Pre -Trigger
Setting
90%
(0% - 100%)
–
Sets the percentage of data to save before the trigger
is detected for the short-term data log. This parameter
is only available when using an LCD keypad.
o5-21
( 1E88)
RUN
Trend Log
Samp ling Time
Selection
0
( 0 - 4)
–
Selects the sampling cycle for the trend log to save data
b e fore the trigger is detected. The trend log works
con currently with the short-term data log. This
p arameter is only available when using an LCD keypad.
0: Trend Log Disabled
1: 0.1 s (About 1 hour)
2: 1 s ( About 10 hours)
3: 10 s ( About 100 hours)
4: 60 s ( About 600 hours)
V / f CL - V / f O LV C L V A OLV O L V / P M A O L V / P M C L V / P M E Z O L V
V / f CL - V / f O LV C L V A OLV O L V / P M A O L V / P M C L V / P M E Z O L V
V / f CL - V / f O LV C L V A OLV O L V / P M A O L V / P M C L V / P M E Z O L V
V / f CL - V / f O LV C L V A OLV O L V / P M A O L V / P M C L V / P M E Z O L V
V / f CL - V / f O LV C L V A OLV O L V / P M A O L V / P M C L V / P M E Z O L V