AT-GS900M Series Command Reference
Section IV: Security and Traffic Control 491
ipdaddr
Specifies the IP destination address. You can also specify the
Variable Length Subnet Mask (VLSM). The default value is any.
ip_add
Specifies an IP address in the format: nnn.nnn.nnn.nnn.
mask_len
Specifies a VLSM after the IP address. Separate the IP address
and VLSM with a slash(/).
tcpsport
Specifies the TCP source port of packets. The range is 0 to 65535.
The default setting is any.
tcpdport
Specifies the TCP destination port of packets. The range is 0 to
65535.The default setting is any.
udpsport
Specifies the UDP source port of packets. The range is 0 to 65535.
The default setting is any.
udpdport
Specifies the UDP destination port of packets. The range is 0 to
65535. The default setting is any.
tcpflags
Specifies the flag in the TCP header. The options are urg, ack, psh,
rst, syn, and fin. QoS filters a packet in which only the specified flag
in the TCP header is on. The default setting is any.
Description
Use this command to display the settings of classifiers. An example of the
command output is shown in Figure 71 on page 492.
To Next Page
Loading...
Need help?
General
