7. System Setup
7.9 Backing up the system
General
In this procedure, you will back up you r system configuration to a US B drive.
Prerequisite
• Ensure that you are familiar with the USB device (Backup/Restore) Menu. For details on this m enu, please refer to c hapter
"System men u > USB device (Backup/Restore)", page 54.
Back up a system configuration file
Use the following steps to back up your system to a US B Drive:
1. Insert a formatted flash drive in the E2’s front-panel USB port.
2. From the S ystem me nu, scroll to the USB Backup/Restore submenu. Select Backup Config.
The USB Backup Con fig su bmenu appears. The navigation cursor appe ars at the default name for the first backup file.
3. If you wish to change the default n ame of the backup configuration, press SE L.UsetheADJUST knob to change the name, as
described in section "Using menu system", page 48. Press SEL again when you com plete the name change.
4. Scroll to Backup Config and press SEL.
Aconfirmation message appears when the bac kup is complete.
166
R5905948 E2 12/12/2014
To Next Page
Loading...
