B. Remote Control Protocol
B.2 E2RemoteCommands
General
This section lists the E 2 remote comm ands, s orted by name.
ATRN
• Description: Performs an Auto Tr ansition on the currently active destinations. The currently selec ted Effect type, rate and edge
width will be used to transition preview to program.
• Command Format: ATRN <transTime>
• Parameters:
<transTime> (optional)
Used to specify a transition time (duration of the transition) in frames. Value ranges from 0 to 1999. A 0 specify a cut transition.
Any non-zero value (within range) will override the transition time in the controller. If this argument is not sp ecified, the current
transition time known by the controller will b e used.
• Examples:
> ATRN 200
(Transition Preview to Pr ogram on cu rrently active de stinations in 200 frames)
> ATRN 0
(Tr ansition P review to Program immediately. T his is a C UT.)
> ATRN
(Transition Preview to P rogram using the transition time set in the controller)
• Query Format: N/A
• Query Response: N/A
PRESET
• Description: Preset S ettings.
• Command Format: PR ESET
• Parameters:
-s (save preset, 1-1000)
-r (recall preset, 1- 1000)
• Examples:
> PRESET -s 1
(Save currently se lected destinations to preset 1)
> PRESET -r 10
(Recall preset 10)
• Query Format: N/A
• Query Response: N/A
R5905948 E2 12/12/2014
293
To Next Page
Loading...
Need help?
General
