Barco E2 - B.1 E2 Remote control Introduction

B. Remote Control Protocol
B.1 E2 Remote control Introduction
General
The user c an remote ly control the E2 v ia a telnet connection to the unit’s IP address.
How accessing the E2 remotely
To access the E2 remote c omm ands, us e the following procedure:
1. In a command prompt window, type a telnet command in the following format:
> telnet nnn.nnn.nnn.nnn 9878
where the n’s represent the E 2 IP address and 9878 is the port.
2. Press Enter
The command prompt appears.
3. At the c omm and prompt, type a specific E2 remote control command and press Enter.
292
R5905948 E2 12/12/2014