InteliDrive DCU Marine - 3.0.0 Global Guide
3
3.2.1 ID-RPU functions 33
3.2.2 ID-RPU overspeed setting 35
4 Installation and wiring 38
4.1 Terminal and dimensions 38
4.1.1 ID-DCU MARINE 38
4.1.2 Communication lines wiring 39
4.1.3 ECU 39
4.1.4 ID DCU MARINE dimensions 39
4.1.5 ID-COM terminals 40
4.1.6 ID-DCU MARINE terminals 41
4.1.7 ID-DCU xx -LT version with display preheating 42
4.1.8 ID-RPU terminals 42
4.1.9 ID-SCM Speed control module 43
4.1.10 ID-SCM1 44
4.1.11 InteliVision 5 CAN, InteliVision 5 CAN Backlit 45
4.1.12 InteliVision 8, InteliVision 8 Marine 47
4.1.13 InteliVision 12Touch OEM 48
4.2 Recommended wiring 50
4.2.1 Bus/Communication architecture 50
4.2.2 Electronic engine without redundancy line 51
4.2.3 Engine without ECU (mechanical engine) 52
4.2.4 I-CB wiring and configuration 52
4.2.5 ID-RPU wiring 53
4.2.6 Recommended wiring acording to DNV rules 53
4.2.7 Wiring example - Complete system without RPU 55
4.3 Getting started 55
4.3.1 How to install 55
4.3.2 Analog as Binary input 57
4.3.3 Analog as three state (tristate) binary input 57
4.3.4 Analog Sensor availabilty with controller 57
4.3.5 Analog Sensors availability with extension modules 58
4.3.6 Binary inputs/outputs on ID-DCU MARINE 59
4.3.7 Binary output separation 60
4.3.8 Connection of ID-DCU MARINE analog inputs 61
4.3.9 ID-DCU MARINE Analog inputs hardware configuration 61
4.3.10 ID-DCU MARINE Analog inputs software configuration 63
4.4 Extension modules 69
4.4.1 Inteli AIN8 69
4.4.2 Inteli AIN8TC 70
To Next Page
Loading...
Need help?
General
