TCD 2015
Fuel system
W 07-06-04
© 06/2006 8218-001
4/14
6
z Mount dial gauge holder (1).
z Tighten screws (2).
A07 012
2
1
© 40499-0
z Insert dial gauge holder (1) with stylus extension.
z Mount stylus with 6 mm pre-tension on the roller tap-
pet.
z Turn the crankshaft alternately in and against engine
direction.
z Check installation position of the dial gauge.
z Adjust dial gauge to "0".
Dial gauge must run on the base circle of
the injection camshaft.
The display of the dial gauge may not
move.
1
© 40500-0
z Set crankshaft with turning gear in engine direction of
rotation (arrow) to ignition TDC, cylinder no. A1.
The locking pin of the turning gear must
snap into the starter gear ring.
© 40502-0
To Next Page
Loading...
