134 Upgrade and Maintenance Manual
RX2520 M4
Hard disk drive (HDD) and solid state drive (SSD)
Figure 49: Inserting the 2.5-inch HDD module
Ê Insert the HDD/SSD module into a drive bay and carefully push back as far
as it will go (1).
Ê Close the locking lever in the direction of the arrow until it engages (2).
Ê When using a RAID array, add the additional HDD/SSD to the RAID array.
I Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see section "Documents you
need at hand" on page 31.
7.3.5.4 Concluding steps
Ê No steps needed.
To Next Page
Loading...
