148 Upgrade and Maintenance Manual
RX2520 M4
Hard disk drive (HDD) and solid state drive (SSD)
7.3.10.5 Installing the third 2.5-inch HDD backplane
Ê Install the third backplane, see section "Installing a 2.5-inch HDD backplane"
on page 142.
Ê Connect the cables to the third backplane, see section "Connecting a 2.5-
inch HDD backplane" on page 143.
Ê Connect the power cable from the third backplane to connector PWR3 on
the system board.
Ê If applicable, install the SAS expander board, see section "Installing the SAS
expander board" on page 149.
Ê Connect the SAS cable to the corresponding controller or to the SAS
expander board.
I For the cable plan, see chapter "Appendix B" on page 411.
7.3.10.6 Installing additional HDD/SSD modules
Ê Insert additional HDD/SSD modules, see section "Installing a 2.5-inch
HDD/SSD module" on page 133.
7.3.10.7 Concluding steps
Ê "Installing the fan holder" on page 64
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 55
Ê "Connecting the power cord" on page 59
Ê "Switching on the server" on page 60
Ê "Verifying system information backup/restore" on page 74
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For more information on how to obtain
and use the ChassisId_Prom Tool, see section "Using the Chassis ID Prom
Tool" on page 93.
Ê "Resuming BitLocker functionality" on page 89
To Next Page
Loading...
Need help?
General