Fujitsu PRIMERGY RX2520 M4

RX2520 M4 Upgrade and Maintenance Manual 139
Hard disk drive (HDD) and solid state drive (SSD)
7.3.7.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Locating the defective component" on page 47.
7.3.7.2 Removing the defective 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module, see section "Removing a 2.5-inch
HDD/SSD module" on page 136.
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling the HDDs or SSDs without installation frame" on page 121.
7.3.7.3 Installing the new 2.5-inch HDD/SSD module
Ê If applicable, install the HDD/SSD in the installation frame, see section
"Handling the HDDs or SSDs without installation frame" on page 121.
Ê Install the HDD/SSD module, see section "Installing 2.5-inch HDD/SSD
modules" on page 132.
7.3.7.4 Concluding steps
Ê If the HDD/SSD is configured in a RAID configuration with a RAID level
higher than "0", the rebuild will start automatically, see section "Performing
a RAID array rebuild" on page 90.