364 Upgrade and Maintenance Manual
RX2520 M4
System board and components
15.4.3 Replacing the iRMC microSD card
15.4.3.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Shutting down the server" on page 48
Ê "Disconnecting the power cord" on page 49
Ê "Getting access to the component" on page 50
15.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section "Removing the
iRMC microSD card" on page 362.
V CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new iRMC microSD card, see section "Installing the iRMC
microSD card" on page 361.
15.4.3.3 Concluding steps
Ê "Reassembling" on page 55
Ê "Connecting the power cord" on page 59
Ê "Switching on the server" on page 60
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: a pair of side-cutting pliers
To Next Page
Loading...
Need help?
General