RX2520 M4
Upgrade and Maintenance Manual 81
Basic software procedures
Resetting the boot retry counter using iRMC web interface
Ê Enter the ServerView iRMC web interface.
Ê Select the Server Management menu.
Ê The following boot retry counter settings are available under ASR&R Options:
Ê Under Retry counter max specify the maximum number of attempts to boot
the operating system (0 to 7).
Ê Under Retry counter the current number of remaining boot attempts is
displayed. Overwrite this value with the maximum number of boot
attempts specified above in order to reset the boot retry counter.
Ê Click Apply for the changes to take effect.
I For more information on iRMC settings, see the iRMC user guides.
5.2.7 Resetting the error status after replacing memory
modules or CPUs
5.2.7.1 Memory modules
ServerView Operations Manager may report a defective memory module in
case of a memory error.
I Important note
After replacing a defective memory module, please check if the error
counter has been reset automatically. If the memory slot is still marked
as failed, please reset the error counter manually using one of the
methods below.
Using ServerView Maintenance Tools (Windows only)
Ê Launch the ServerView Maintenance Tools:
Start > Apps > Fujitsu > Maintenance Tools
Ê Choose the Memory status tab.
Ê Select the memory module which shows the pre-failure status.
Ê Click on Reset Status.
I The Reset Status button will only be available if the selected memory
module contains errors.
To Next Page
Loading...
Need help?
General