Fujitsu PRIMERGY RX2520 M4

RX2520 M4 Upgrade and Maintenance Manual 345
Serial interface
14.3 Replacing the serial interface
14.3.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Shutting down the server" on page 48
Ê "Disconnecting the power cord" on page 49
Ê "Getting access to the component" on page 50
Ê If applicable, remove the expansion card from slot 4, see section "Removing
expansion cards" on page 213.
14.3.2 Removing the defective serial interface
Ê Remove the serial interface, see section "Removing the serial interface" on
page 343.
14.3.3 Installing the new serial interface
Ê Install the serial interface, see section "Installing the serial interface" on
page 340.
14.3.4 Concluding steps
Ê If applicable, install the expansion card in slot 4, see section "Installing
expansion cards" on page 207.
Ê "Reassembling" on page 55
Ê "Connecting the power cord" on page 59
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tool: hexagon screw driver 5 mm