Fujitsu PRIMERGY RX2520 M4 - Removing the SAS Expander Board Holder

RX2520 M4 Upgrade and Maintenance Manual 177
Hard disk drive (HDD) and solid state drive (SSD)
7.4.9.2 Removing the SAS expander board holder
Figure 80: Disconnecting the cables from the SAS expander board
Ê Disconnect the two SAS cables from the SAS expander board (see arrows).
Ê If applicable, disconnect the OOB cable from the backplane (see circle).
Figure 81: Removing the SAS expander board holder (A)
Ê Remove the screw from the SAS expander board holder (see circle).