216 Upgrade and Maintenance Manual
RX2520 M4
Expansion cards and backup units
9.4.3.3 Installing the expansion card
Ê If applicable, install the slot bracket, see section "Installing a slot bracket" on
page 198.
Ê Install the expansion card, see section "Installing an expansion card" on
page 208.
9.4.3.4 Concluding steps
Ê "Reassembling" on page 55
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 59
Ê "Switching on the server" on page 60
Ê "Enabling replaced components in the BIOS" on page 84
Ê Inform the customer about changed WWN and MAC addresses, see section
"Looking up changed MAC/WWN addresses" on page 91.
Ê "Updating expansion card firmware (iRMC S5)" on page 76
Ê "Resuming BitLocker functionality" on page 89
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer.
For more information, see section "Note on network settings
recovery" on page 215.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing a system board" on page 95.