Fujitsu PRIMERGY RX2520 M4 - Concluding Steps; Replacing the ID Card Holder; Preliminary Steps

RX2520 M4 Upgrade and Maintenance Manual 335
Front panel
13.4.1.4 Concluding steps
Ê "Installing the fan holder" on page 64
Ê "Installing the air duct" on page 62
Ê "Reassembling" on page 55
Ê "Connecting the power cord" on page 59
Ê "Switching on the server" on page 60
Ê "Verifying system information backup/restore" on page 74
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For more information on how to obtain
and use the ChassisId_Prom Tool, see section "Using the Chassis ID Prom
Tool" on page 93.
Ê "Resuming BitLocker functionality" on page 89
13.4.2 Replacing the ID card holder
13.4.2.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 67
Ê "Locating the defective server" on page 45
Ê "Shutting down the server" on page 48
Ê "Disconnecting the power cord" on page 49
Ê If applicable, "Removing 2.5-inch HDD/SSD modules" on page 135.
Ê "Getting access to the component" on page 50
Ê "Removing the fan holder" on page 63
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less