RX2520 M4
Upgrade and Maintenance Manual 73
Basic software procedures
5.2.1.2 Updating or recovering the iRMC
iRMC flash procedure
Ê Prepare a USB stick including the bootable iRMC firmware update image.
Ê Connect the USB stick containing the iRMC firmware to a USB port.
Ê Restart the server. The system will start the POST process.
Ê During POST, press [F12] and select the connected USB stick as boot
device. The system will detect the USB stick.
Ê Choose one of the following options from the update tool menu to start the
iRMC update process:
Normal
Choose this option to update an existing system board.
Initial Choose this option if the system board has been replaced prior to the
iRMC update procedure. This option will perform all relevant flash
procedures in a row, including the iRMC firmware and bootloader.
V CAUTION!
Do not interrupt the iRMC upgrade process after it has started. If the
process is interrupted, the iRMC may be permanently corrupted.
I If the iRMC does not work after flashing, disconnect the system from
the mains and reconnect it again.
Ê After completion of the flash process, remove the USB stick and restart the
server.
To Next Page
Loading...
Need help?
General