50 Upgrade and Maintenance Manual
RX2520 M4
Basic hardware procedures
4.4 Getting access to the component
V CAUTION!
●
Only for non-hot plug components:
Before removing or attaching covers, turn off the server, all peripheral
devices, and any other connected devices. Because there is a risk of
electric shock or damage, please disconnect all power cords from the
outlet.
●
The top cover must be replaced as soon as possible for purposes of
cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
●
For more safety information, see chapter "Important information" on
page 33.
4.4.1 Extending the server out of the rack
V CAUTION!
●
Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
●
Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
●
For more safety information, see chapter "Important information" on
page 33.
Ê Remove all remaining external cables from the rear I/O panel and expansion
cards.
Ê If you are not using a cable mounting arm (CMA kit), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
To Next Page
Loading...
Need help?
General