112 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Basic hardware procedures
4.9 Closing the server
V CAUTION!
● Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
● In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY TX300 S7 / RX350 S7 server must not run while the
top / side cover is removed.
● For further safety information, please refer to chapter "Important
information" on page 51.
4.9.1 Rack model
4.9.1.1 Installing the rack mounting frame
Figure 47: Installing the rack mounting frame (A)
Ê Fit the rack mounting frame on the server front.
To Next Page
Loading...
