Fujitsu PRIMERGY TX300 S7 - Installing the Slimline ODD into the Extension Box

716 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
I The front cover only needs to be removed in order to remove
accessible drive dummy covers (see section "Removing accessible
drive dummy covers" on page 656). If the HDD extension box is
already installed in the server and will be removed in order to install
a slimline ODD or LSD module, skip this step.
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
Ê If the HDD extension box is already installed in the server, disconnect all
cables from the HDD backplane and accessible devices and remove the
extension box as described in section "Removing the 2x 3.5-inch HDD
extension box" on page 322.
12.6.1.3 Installing the slimline ODD into the extension box
Figure 499: Removing the slimline ODD dummy module