Fujitsu PRIMERGY TX300 S7 - Trusted Platform Module (TPM); Installing the TPM Board; Preliminary Steps; Required Tools

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 833
System board and components
14.3 Trusted Platform Module (TPM)
This section provides information on how to install, remove or replace the
Trusted Platform Module (TPM).
14.3.1 Installing the TPM board
14.3.1.1 Required tools
● Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
● Installing the TPM:
– Bit screw driver
– TPM bit insert
(
*
)
(
*
)
For the Japanese market:
– TPM module fixing tool (S26361-F3552-L909)
14.3.1.2 Preliminary steps
Before installing the TPM board, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 141.
Ê Locate the desired server as described in section "Locating the defective
server" on page 64.
Ê Shut down the server as described in section "Shutting down the server" on
page 71.
Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes