712 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
12.5.3 Replacing a slimline ODD or LSD
12.5.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing a slimline ODD or LSD:
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
12.5.3.2 Preliminary steps
Before replacing a slimline ODD or LSD, perform the following steps:
Ê Locate the desired server as described in section "Locating the defective
server" on page 64.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 144.
Ê Shut down the server as described in section "Shutting down the server" on
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section "Disconnecting the server
from the mains" on page 72.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 76.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 77.
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
