376 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Hard disk drives / solid state drives
Figure 236: Installing accessible drive covers
Ê Remove the SAS expander board from the chassis
Ê Change SAS cabling according to the new server configuration as described
in sections "2.5-inch HDD / SSD configurations" on page 199 and "3.5-inch
HDD configurations" on page 258.
7.5.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
To Next Page
Loading...
