Fujitsu PRIMERGY TX300 S7 - Installing the Slimline ODD into the HDD Extension Box

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 333
Hard disk drives / solid state drives
Removing accessible drive covers
Figure 205: Removing an accessible drive covers
I Removing accessible drive covers is illustrated by the example of the
tower server. In case of the rack front cover, the procedure is identical.
Ê Turn the front cover face down.
Ê Press in on the lugs on either side of the drive cover.
Ê Fold up (1) and remove the desired accessible drive covers (2).
7.4.5.4 Installing the slimline ODD into the HDD extension box
Ê If applicable, install the slimline ODD into the new 2x 3.5-inch HDD
extension box as described in section "Installing the slimline ODD into the
HDD extension box" on page 740.