Fujitsu PRIMERGY TX300 S7 - Removing the Multibay Box; Removing the Slimline ODD from the Multibay Box; Removing the LSD Module from the Multibay Box; Installing the Slimline ODD into the Multibay Box

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 713
Accessible drives
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
I Removing the front cover is not required in order to replace the slimline
ODD or LSP in the Multibay box.
12.5.3.3 Removing the Multibay box
Ê Remove all cables from the slimline ODD.
Ê Remove the LSD cable from system board connector SMB 1.
Ê Remove the Multibay box from the server as described in section "Removing
the Multibay box" on page 713.
12.5.3.4 Removing the slimline ODD from the Multibay box
Ê Remove the defective slimline ODD from the Multibay box as described in
section "Removing the slimline ODD from the Multibay box" on page 706.
12.5.3.5 Removing the LSD module from the Multibay box
Ê Remove the defective LSD module from the Multibay box as described in
section "Removing the LSD module from the Multibay box" on page 708.
12.5.3.6 Installing the slimline ODD into the Multibay box
Ê Install the new the slimline ODD into the Multibay box as described in section
"Installing the slimline ODD into the Multibay box" on page 713.
12.5.3.7 Installing the LSD module into the Multibay box
Ê Install the new LSD module into the Multibay box as described in section
"Installing the LSD module into the Multibay box" on page 692.
12.5.3.8 Installing the Multibay box
Ê Reinstall the Multibay box as described in section "Installing the Multibay
box" on page 694.