TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 777
Front panel and external connectors
13.1.6 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
Ê Verify whether a backup copy of the system board settings has been
successfully transferred to the Chassis ID EPROM as described in section
"Verifying system information backup / restore" on page 152.
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 168.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 159.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 165.
To Next Page
Loading...
