Fujitsu PRIMERGY TX300 S7 - Removing the 8 X 2.5-Inch HDD Extension Box; Installing the 8 X 2.5-Inch HDD Extension Box; Concluding Steps

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 367
Hard disk drives / solid state drives
7.4.10.3 Removing the 8x 2.5-inch HDD extension box
Ê Unlock and pull the 8x 2.5-inch HDD extension box out of its installation bays
as described in section "Removing the 8x 2.5-inch HDD extension box" on
page 359.
7.4.10.4 Installing the 8x 2.5-inch HDD extension box
Ê Install the new 8x 2.5-inch HDD extension box as described in section
"Installing the 8x 2.5-inch HDD extension box" on page 349.
7.4.10.5 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Reinstall all hard disk drives into their original slots in the HDD extension box
as described in section "Installing 3.5-inch HDD modules" on page 272.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.