Fujitsu PRIMERGY TX300 S7 - Installing the Heat Sink

644 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Processors
When reusing a heat sink
Ê Ensure that all residual thermal paste has been thoroughly cleaned off the
copper surface of the heat sink.
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 649.
11.5.3.2 Installing the heat sink
Figure 441: Installing the heat sink (A)
Ê Align the heat sink with the uncovered copper heat pipes (H, see above)
facing towards the server top.
H