Fujitsu PRIMERGY TX300 S7 - Reassembling the Front Panel Module; Reinstalling the Front Panel Module

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 801
Front panel and external connectors
Figure 561: Mounting the front VGA connector
Ê Run the front VGA cable through the mounting bracket on the front panel
frame as shown (1).
Ê Secure the front VGA connector with two hexagon bolts (2, see close-up).
13.3.1.6 Reassembling the front panel module
Ê Mount the front panel module cover on the front panel frame as described in
section "Mounting the front panel module cover" on page 769.
13.3.1.7 Reinstalling the front panel module
Ê Reinstall the front panel module as described in section "Installing the front
panel module" on page 771.