754 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
12.7.2.5 Installing accessible drive dummy covers
I if the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
the following description does not apply. Please proceed as described in
section "Installing the 4x 3.5-inch HDD extension box" on page 334.
Installing accessible drive filler covers
Ê Install accessible drive filler covers (C26361-K644-C933) into the empty
installation bays 1, 2 and 3 as described in section "Installing accessible
drive dummy covers" on page 681.
V CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Installing accessible drive covers
Ê Install accessible drive covers (C26361-K644-C60) into installation bays 1,
2 and 3 of the front cover as described in section "Installing accessible drive
dummy covers" on page 681.
12.7.2.6 Installing the 4x 3.5-inch HDD extension box
Ê If the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
prepare the accessible drive mounting brackets and install the extension box
into installation bays 1, 2 and 3 as described in section "Installing the 4x 3.5-
inch HDD extension box" on page 334.
12.7.2.7 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
To Next Page
Loading...
