TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 527
Expansion cards and backup units
9.5.2 Replacing a GPGPU / coprocessor card
9.5.2.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a GPGPU card / coprocessor card:
– GPGPU card Intel Xeon Phi:
– Phillips PH1 / (+) No. 1 screw driver
– Coprocessor card Nvidia TESLA K20 / K20X:
– Phillips PH2 / (+) No. 2 screw driver
9.5.2.2 Preliminary steps
Ê Proceed as described in chapter "Before you start" on page 39
9.5.2.3 Removing the GPGPU air duct
Ê Proceed as described in section "Installing the GPGPU air duct" on
page 509 in reverse order.
9.5.2.4 Removing a GPGPU / coprocessor card
Ê Disconnect all cables from the GPGPU / coprocessor card(s).
Ê Proceed as described in section "Installing a GPGPU or coprocessor card"
on page 498 in reverse order.
9.5.2.5 Installing a GPGPU / coprocessor card
Ê Proceed as described in section "Installing a GPGPU or coprocessor card"
on page 498.
Field Replaceable Units (FRU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
