TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 283
Hard disk drives / solid state drives
Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at http://manuals.ts.fujitsu.com
(http://jp.fujitsu.com/platform/server/primergy/manual/ for the Japanese
market) or from the ServerView Suite DVD 2 supplied with your
PRIMERGY server.
7.3.8.3 Removing a 3.5-inch HDD module
Ê Remove the HDD module to be replaced from the server as described in
section "Removing a 3.5-inch HDD module" on page 279.
7.3.8.4 Installing a 3.5-inch HDD module
Ê Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page 272.
7.3.8.5 Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page 119.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 166.
To Next Page
Loading...
