Fujitsu PRIMERGY TX300 S7 - Installing a 3.5-Inch HDD Dummy Module

280 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Hard disk drives / solid state drives
Figure 159: Removing a 3.5-inch HDD module
Ê Pull the HDD module completely out of its bay.
7.3.7.4 Installing a 3.5-inch HDD dummy module
V CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.