TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 241
Hard disk drives / solid state drives
Figure 124: Installing the intrusion switch holder (B)
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw.
7.2.8.8 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections "Installing a 2.5-inch HDD / SSD module" on
page 216 and "Installing a 2.5-inch HDD / SSD dummy module" on
page 222.
I For detailed information on HDD mounting order, refer to section "2.5-
inch HDD / SSD configurations" on page 199.
To Next Page
Loading...
