562 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Expansion cards and backup units
9.7.4.4 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
9.7.5 Removing an FBU
V CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" on page 60.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
To Next Page
Loading...
