178 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Power supply
Figure 80: Installing a PSU module
Ê Push the PSU module into its slot (1) as far as it will go until the locking latch
snaps in place (2).
V CAUTION!
Ensure that the PSU module properly engages in its slot and is locked
in position in order to prevent it from sliding out of the chassis during
transportation.
Ê If applicable, fold down the handle on the PSU module.
6.2.4 Concluding steps
Perform the following procedure to complete the task:
Ê Connect an AC power cord to the new power supply module and secure it
with a cable bracket as described in section "Connecting the server to the
mains" on page 133.
To Next Page
Loading...
