TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 819
System board and components
14.2 USB Flash Module (UFM)
This section provides information on how to install, remove or replace the USB
Flash Module (UFM).
14.2.1 Installing the UFM board
14.2.1.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing the UFM: tool-less
14.2.1.2 Preliminary steps
Before installing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 141.
Ê Disable boot watchdog functionality as described in section "Disabling
SVOM boot watchdog functionality" on page 142.
Ê Locate the desired server as described in section "Locating the defective
server" on page 64.
Ê Shut down the server as described in section "Shutting down the server" on
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section "Disconnecting the server
from the mains" on page 72.
Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
