Fujitsu PRIMERGY TX300 S7 - Cabling the SAS Backplanes; Concluding Steps

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 307
Hard disk drives / solid state drives
Figure 184: Mounting the 3.5-inch HDD bay top cover (C)
Ê Secure the HDD bay top cover to the chassis with five M3 x 4.5 mm screws
(see blue arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw (see orange arrow).
7.3.10.8 Cabling the SAS backplanes
Ê Connect SAS and power cables to the 2.5-inch SAS backplanes as
described in section "8x 3.5-inch HDD SAS backplane cabling" on page 261.
7.3.10.9 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.