308 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Hard disk drives / solid state drives
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Install HDD modules or HDD dummy modules into the additional HDD slots
as described in sections "Installing a 3.5-inch HDD module" on page 274
and "Installing a 3.5-inch HDD dummy module" on page 280.
I For detailed information on HDD mounting order, refer to section "3.5-
inch HDD configurations" on page 258.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 165.
To Next Page
Loading...
