TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 909
16 Cabling
Safety notes
V CAUTION!
● Always hold cables by their connectors when disconnecting them.
Never pull on the cable to disconnect cables.
● Ensure that none of the cables are scraped, strained or otherwise
damaged while replacing system components.
● Immediately replace cables with damaged shielding.
● Always use shielded network cables.
16.1 List of used cables
I The numbers in the cable list correspond to those shown in the cabling
plans below.
No. Name Length
Number
(T26139-)
Routing
1 HDD Power Cable
750 / 550 /
450 mm
Y3952-V601
Power backplane to SAS
backplanes / HDD ext. box
2 PSU Signal Cable 300 mm Y4027-V1
Power backplane to system
board
3 HDD / ODD Power Cable 410 mm Y4029-V201
SAS backplane to HDD
extension box or system
board
4 System Power Cable 500 mm Y3758-V9
Power backplane to system
board
5
Backup Drive Power
Cable
410 mm Y4029-V1
Backup drive to system
board or power backplane
6 ODD SATA Power Cable 410 mm Y3930-V601 ODD to SAS backplane
7
SAS Backup Drive
Power / Data cable
410 / 700
mm
Y3969-V401
SAS Backup drive to system
board connector SAS 1-4
8A
Slimline ODD SATA
Power Cable
400 mm Y3986-V302
ODD to system board or SAS
backplane
8B 500 mm Y3986-V305 ODD to SAS backplane
Table 6: List of used cables
To Next Page
Loading...
