TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 675
Accessible drives
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 155.
12.3 Removing accessible drives
12.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing accessible drives: tool-less
12.3.2 Preliminary steps
Before removing an accessible drive, perform the following steps:
Ê Locate the desired server as described in section "Locating the defective
server" on page 64.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 144.
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
