560 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Expansion cards and backup units
9.7.4 Removing a BBU
V CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" on page 60.
9.7.4.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing a BBU: tool-less
9.7.4.2 Preliminary steps
Before removing a BBU, perform the following steps:
Ê Locate the defective server as described in section "Locating the defective
server" on page 64.
Ê Shut down the defective server as described in section "Shutting down the
server" on page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section "Disconnecting the server
from the mains" on page 72.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 76.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 77.
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
To Next Page
Loading...
