TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 597
Main memory
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
10.3.3 Removing a memory module
Ê Identify the desired memory slot according to the mounting order described
in section "Memory sequence" on page 584.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 584.
Figure 407: Removing memory modules (A)
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector.
I For lack of space, it is necessary to remove the rear fan modules
(fans 5 and 6) in order to install or remove memory modules in
channels E and F or channels G and H. For further information,
please refer to section "Removing a rear fan module" on page 397.
To Next Page
Loading...
