596 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Main memory
10.3 Removing memory modules
10.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing memory modules: tool-less
10.3.2 Preliminary steps
Before removing a memory module, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 141.
Ê Disable boot watchdog functionality as described in section "Disabling
SVOM boot watchdog functionality" on page 142.
Ê Locate the desired server as described in section "Locating the defective
server" on page 64.
Ê Shut down the defective server as described in section "Shutting down the
server" on page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section "Disconnecting the server
from the mains" on page 72.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 76.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 77.
Ê Bring the server to its horizontal position.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
To Next Page
Loading...
