TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 313
Hard disk drives / solid state drives
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
7.4.2.3 Removing accessible drive dummy covers
Removing accessible drive filler covers
Figure 191: Removing an accessible drive filler cover
Ê Hold the accessible drive filler cover by its two handle recesses and pull it
out of the desired installation bays.
V CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
To Next Page
Loading...
