EasyManua.ls Logo

Fujitsu PRIMERGY TX300 S7 - Installing PCI Slot Brackets

Fujitsu PRIMERGY TX300 S7
962 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 483
Expansion cards and backup units
9.4.2.5 Installing PCI slot brackets
I If the GPGPU card is not replaced by a new GPGPU card, reinstall PCI
slot brackets and the PCI slot mounting bar.
V CAUTION!
Always replace slot brackets into unused PCI slot openings to comply
with applicable EMC regulations and satisfy cooling requirements.
Figure 309: Installing a PCI slot bracket (A)
Ê If applicable, remove all remaining screws from the installed PCI slot
brackets.
Ê Insert PCI slot brackets into the unused PCI slot openings.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX300 S7

Related product manuals