Fujitsu PRIMERGY TX300 S7 - Preparing the SAS RAID Controller

530 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Expansion cards and backup units
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 76.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 77.
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
9.6.1.3 Preparing the SAS RAID controller
Figure 364: SAS RAID controller with RAID card holder (C26361-K644-B944)