Fujitsu PRIMERGY TX300 S7 - 15 Converting a Tower Server to a Rack Server; Required Tools

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 883
15 Converting a tower server to a
rack server
This chapter provides information on how to convert a tower server to a rack
model.
Safety notes
For further information, please refer to chapter "Important information" on
page 51.
15.1 Required tools
● Preliminary and concluding steps: tool-less
● Converting the server model:
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver
Upgrade and Repair Units (URU)
Average task duration: 20 minutes