Fujitsu PRIMERGY TX300 S7 - Removing an Expansion Card

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 425
Expansion cards and backup units
9.2.2.3 Removing an expansion card
Figure 266: Removing an expansion card (A)
Ê If applicable, remove SFP+ transceiver modules from the expansion card,
as described in section "Replacing SFP+ transceiver modules" on page 582.
Ê Press out on the locking latch to disengage the PCI slot bracket locking bar
(1, see close-up).
Ê Fold up (2) and remove (3) the PCI slot bracket locking bar.